DMX Scene panel DMX-P11

DMX Scene panel DMX-P11

Button and indicator description

Button and indicator description
Switch: Long press on/off, the center indicator light is high or low
Scenario group: Short press, The corresponding indicator is steady on
Mode: Tap to select scene (Scene indicator is on)/Color (Scene indicator is off)
Brightness: Short press, Level 10 dimming
Select a scenario: Select a scenario with a maximum value of 5, Short press,
The corresponding indicator blinks for three times and then turns off.

For example, a total of 30 scene number keys 1-6 correspond to 1-5, 6-10… 26-30, number of scenes,
When scenario group 1 is selected, if indicator 2 blinks for 3 times and then turns off, it indicates scenario 0.
Press the scene selection button, the scene switches from 1-5, and the indicator blinks from 2-6.
When scenario group 3 is selected, if indicator 1 blinks for 3 times and then turns off, it indicates scenario 11.
Press the scene selection button, the scene switches in 11-15, the indicator blinks in 1, 2, 4, 5, 6,

Input/output Port

Input Port: 8pin 3.81mm Plug and pull terminals
Port Order: RS485+ RS485- GND DMX+ DMX- GND GND VIN
Input Voltage: 5-12V
Input/Output Signal: 1.Micro USB
2. DMX512 Output
3. RS485 Signal

Supports a maximum of 30 scenarios (6 x 5)
Support USB scene editing
Supports USB flash drive mode to copy scene files to the device
Supports external 485 command control. For details about the control commands, see the command format document
Support 485 cascade control, set a group of multiple slaves, the device defaults to the slave, using the 485 instruction protocol Set one device to host mode. When the system is running, all the slave power indicators blink No flicker. The control host enables all cascaded devices to respond simultaneously.
Device panel control for scene selection, RGB color ring and 10-level dimming,
When the device is in scene mode, touch the color ring and dimmer buttons, prompting the current scene number to blink.